4T65-E All Wheel Drive Problems Noise and Gear Failures
Ed Lee
The4T65-Ewas introduced in 1997 in several vehicles equipped with the supercharged 3.8L engine, and some non-supercharged 3.4L and 3.8L engines. It was considered to be the big brother to the4T60-E.transaxle.
The differential for the front-wheel-drive 4T65-E rests between the final drive ring gear and the final drive housing. Since the differential is free to move between these two members, its end play must be regulated. The parameters for the end play are a minimum of .005” and a maximum of .025”, and final drive selective thrust washers are used to adjust this measurement. There are 10 different selective thrust washers ranging from .055” to .095” thick, and they are installed just as they have been since the introduction of GM’s first frontwheel transaxle, the 125. In 1999 an all-wheel-drive version of the 4T65-E was offered in the 3.4L Montana.
Except for the differential, the all-wheel-drive 4T65-Etransmission与全轮驱动相同。全轮驱动部分的驱动齿轮安装在差的壳体附近，差动壳体靠近，在其中安装在前轮驱动差分上。
When power is transmitted through gear-to-gear contact, the end play of the gears must be as close to zero as possible. For this reason, the differential of the all-wheel-drive 4T65-E is attached to the transfer case housing. The end of the differential is threaded, and a large nut is used to secure the differential to a bearing in the housing. Since the differential is affixed to the housing, the end play of the mating parts must be adjusted inboard of the differential. This is done by moving the selective thrust washer to a new position, at the drive end of the differential. Material is removed from the parking gear and the selective washer is sandwiched between the parking gear and the final drive sun gear.
There are 21 different selective washers ranging from .061” to .105” thick. The end play is checked in the same manner as the clutch clearance is checked in the rear-wheel drive Chrysler overdrives. If you follow the directions correctly, you will end up with an end play between .020” and .024”. The selective thrust washers for the all-wheel drive transaxles do not have a full circle I.D like the front-wheel-drive washers.
The five locating tabs on the all-wheeldrive washers only center the washers on the sun gear shaft. The washers are free to rotate on the shaft, and since the shaft is considerably harder than the washers, they wear quickly. The material that the shaft removes from the washers passes through the gears of the differential and causes damage similar to that seen inFigure 1. At this point, replacing the selective washer with an OE replacement is your only option.
 |
 |
However, if you are really lucky, you may find a front-wheel-drive parking gear that is the same thickness as the combined thicknesses of the selective washer and the all-wheel-drive park gear. Another alternative is to find a front-wheel-drive park gear that is thicker than the washer and gears combined and have it machined to the proper thickness. Either way will work, and you will be safer than using the OE washer.
特别感谢Deltrans的船员，以帮助他们准备这篇文章。
Ed Lee is a Sonnax Technical Specialist and a member of theTASC Force®(Technical Automotive Specialties Committee), a group of recognized industry technical specialists, transmission rebuilders and Sonnax Industries Inc. technicians.
Related Units
While Sonnax makes every effort to ensure the accuracy of technical articles at time of publication, we assume no liability for inaccuracies or for information which may become outdated or obsolete over time.